![]() ![]() The DJI Action 2 Camera Unit and its Waterproof Case have an IP68 waterproof rating. It is recommended to use the DJI Action 2 Waterproof Case if you intend on using DJI Action 2 underwater for long periods (such as when diving) or under high water pressure conditions (such as when cliff diving). Only the Action 2 camera unit is waterproof.The front touchscreen module and power module are not waterproof. ![]() Only possible when connected with the Front Touchscreen Module.Ģ. Remote control: rocker × 2, scroll wheel × 1, bottom button × 6, with backlight, top button × 1 (right).Audio: Built-in speaker × 1, built-in microphone × 2.Screen: 5.46 inch, 1080P, 16 million colors, capacitive touch screen.Dimensions: 217 × 106.5 × 31mm (the whole machine does not contain external antenna and rocker).Power consumption: the average power consumption of the single-sided module is less than 4W.MMCX antenna jack x 2: used for signal transmission and ground communication.Indicator x 2: used to indicate the frequency and picture status.Keyhole x 1: for frequency and status reset.Micro USB x 1: for debugging upgrades, support OTG mode.4 Pin interface x 1 : Two 3.3V level RC output connectors (S.bus in phase, S.bus inverting or PPM signal output, ground terminal control).3 Pin interface x 1:3.3V / 5V level UART interface.2 Pin interface x 1:5V-12V power input interface.Micro HDMI x 2: Input for external camera video signals. ![]() M2 (E) connector connection between daughter board and core.The RF daughter board completes the function of transmitting and receiving signals.Among them, the video daughter board completes the input bridge function of theHDMI signal.Appearance: core board + video daughter board + structure of RF daughter board.Frequency Band: 2.4GHz ISM Receive sensitivity: BW Interference recovery: Transmission Distance: FCC 20km CE / SRRC 12km Image transmission delay: ≤ 110ms Image transmission: / 60fps transmission.T860 SDR: A7 + DSP Storage: Sky: LPDDR3: 1GB Ground: LPDDR3: 2GB Sky / Ground: EMMC: 4GB.Processor: SoC – Pinecone S1 AP: 4 x large core, Cortex A53, 2.2GHz 4 x small core, Cortex A53, 1.4GHz GPU: 4 core, Mali.Custom channel button and PWM value assignment.Īir Unit and Controller hardware information:.Independent Mavlink commands camera buttons and scroll wheel channels.Built-in QGC open source ground station with adaptable apm and px4 firmware for direct flight function.The integrated digital transmission and image transmission can simultaneously transmit the flight data of the autopilot and the image output by the camera to the remote controller.Dual S.bus signal output for simultaneous control of autopilot and pan/tilt cameras.Supports dual HDMI 1080P 60fps video input, which can be modified through the QGC interface.Herelink allows RC control, HD video and telemetry data to be transmitted upto 20km between the ground station and air unit, the Herelink remote controller features custom Solex TX and QGC applications and both air unit and ground station feature an integrated 8 core SOC for custom application development. Herelink is an integrated remote controller, ground station and wireless digital transmission system designed to be used with the Cube Autopilot, Ardupilot or PX4.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |